Tile Path

The Tile Path command may be used to apply a repetative decoration to a font. A decoration is copied into the selection (this is the "tile") and the command is invoked on a character. All paths in that character will be replaced by the tile fit to the curve.

Consider the following:

The tile

Two paths to be tiled.

The result.

The tile has been replicated (and warped) to follow the original contours.


The Tile Path dialog gives you a few choices to control how the tile is placed. The tile can be either centered on the path, or be tangent to the left edge of the path (for a clockwise path, the left edge is outside the path), or be tangent to the right edge (for a clockwise path the right edge is inside the path).

You can also chose whether you want the tile to be tiled without scaling (in which case you will probably be left with a fraction of the tile at one end), tiled with scaling (the tile will be scaled so that it fits on the path an integral number of times), or simply scaled (in which case there will be exactly one tile and it will be scaled to be as long as the path.

left (outside)

center

right (inside)

tile

tile & scale

scale

-- Prev -- TOC -- Next --